Ref. 5471 R. F. Transmitter For 1 System; Operating; Assigning A System; Inverting The Movement - Mottura 5471 Manual De Instrucciones, Uso Y Mantenimiento

Using the transmitter Ref. 5471 it is possible to control a single system. The system is monitored throughout
the various phases of the movement and its status is communicated to the user by means of the LED LD0.
When used for the first time (or if no system is assigned to the transmitter) LED LD0 flashes twice when any
button is pressed (except " Setting " and " Limit ").
The factory settings are as follows:
➢ buttons " Λ " - " V " - "
➢ button " – " stops the system;
➢ button " Setting " activates the setting procedure;
➢ button " Limit " activates the setting of limit stops;
➢ the LD0 LED signals the status of the system (see "LED signals");
➢ the LD LED signals the information regarding the setting procedures.
Note:
• Using the transmitter Ref. 5471 up to 4 systems can be controlled simultaneously. In this case the
assigning procedure must be performed separately on each different system. The controls given will be
performed simultaneously by all the assigned systems.
• The first time any button is pressed after the transmitter turns itself off causes it to reactivate. The LED
associated with the last system moved comes on and at this point it will be possible to use the transmitter
as normal.
A system can be associated with the transmitter by means of the assigning procedure.
1. Press button " Setting " until LED LD flashes 5 times followed by 3 quick flashes;
2. Press the R. F. button of the system you wish to associate until the respective LED comes on (refer to the
relative technical manual of system).
The system transmits its own identification code to the transmitter (5 quick flashes of the LED LD0 confirm that
the assigning procedure has been successful).
The activation controls sent by the transmitter can be inverted by means of the movement inversion
procedure.
This procedure can be useful when pressing a given button has the opposite effect on the system to what was
expected (for example when pressing the "
button the system moves upwards).
1. Press button " Setting " until LED LD flashes 5 times followed by 3 quick flashes;
2. Press button " Λ " or " V " for inverted the movement (3 flashes of LED LD0 confirm the selection);
3. Press button the " Setting " again (5 quick flashes of the LED LD confirm that the procedure has been
successful).
10

Ref. 5471 R. F. Transmitter for 1 system

LD0
Limit
< >
" - " " activate the system;

Assigning a system

Inverting the movement

>
" button the system moves to the left, or when pressing the " V "
LD

Operating

En 2
Z803 rA
Setting