Deleting A System; Adding Systems To/ Deleting Systems From Group Controls; Inverting The Movement; Button Rotation - Mottura 5471 Manual De Instrucciones, Uso Y Mantenimiento

By means of the deletion procedure one or more systems can be removed from the transmitter memory.
1. Press button " Setting " until LED LD flashes 5 times followed by 3 quick flashes;
2. Select with the "
LED must be on);
3. Press button "
4. Switch off of LEDs confirm that the procedure for deleting has been successful.
The systems assigned to the transmitter Ref. 5474 can be controlled individually or simultaneously if they are
set to belong to the group. This affiliation or not is defined by the following procedure.
1. Press button " Setting " until LED LD flashes 5 times followed by 3 quick flashes;
2. Select with the "
the group control (the associated LED must be on). If, as well as this, the LED LD0:
➢ is Off – the system does not belong to the group. If you wish to add it, press the "
LD0 switches on);
➢ is On – the system belongs to the group. If you wish to remove it, press the "
LD0 switches off);
3. Repeat from point 2 to add or to remove another system from the group control;
4. Press button " Setting " (5 quick flashes of the LED LD confirm that the procedure has been successful).
Note: if one or more systems have been set to belong to the group, in normal use when the group is selected,
the LEDs associated to these systems will come on.
The activation controls sent by the transmitter can be inverted by means of the movement inversion
procedure.
This procedure can be useful when pressing a given button has the opposite effect on the system to what was
expected (for example when pressing the "
button the system moves upwards).
1. Press button " Setting " until LED LD flashes 5 times followed by 3 quick flashes;
2. Select with the "
the movement (the associated LED must be light up);
3. Press button " Λ " or " V " for inverting the movement (3 flashes of LED LD0 confirm the selection);
4. Press the " Setting " button again (5 quick flashes of the LED LD confirm that the procedure has been
successful).
By means of the button rotation procedure the factory settings of the transmitter Ref. 5474 can be
changed from:
< >
➢ " " and "
➢ " Λ " and " V " activation control
to
➢ " Λ " and " V " selection
< >
➢ " " and "
The first configuration is suitable for systems where the motion is vertical (roller blinds, soft shade curtains
etc.) while the second is suitable for systems whose motion is horizontal (draped curtains, vertical, etc.).
1. Press button " Setting " until LED LD flashes 5 times followed by 3 quick flashes;
2. Press button " Limit "
3. 6 flashes of the LED LD confirm that the button rotation procedure has been successful).
12
>
" button (or with the "
–
" for 5 sec, also LED LD0 lights on;

Adding systems to/ Deleting systems from group controls

>
" button (or with the "

Inverting the movement

>
>
" button (or with the "
" selection
" activation control

Deleting a system

<
" button) the system that you wish to delete (the associated
<
" button) the system that you wish to add to or remove from
" button the system moves to the left, or when pressing the " V "
<
" button) the system to which you wish to apply inversion of

Button rotation

En 4
Z803 rA
–
" button (the LED
–
" button (the LED