Setting Limit Stops (Ref. 5471- 5474); Reset (Ref. 5471- 5474); Intermediate Limit Stops ( Ref. 5471- 5474); Changing The Battery (Ref. 5471- 5474) - Mottura 5471 Manual De Instrucciones, Uso Y Mantenimiento

This procedure allows to set the limit stops in the enabled digital systems.
1. Press button " Limit " until LED LD flashes 5 times followed by 3 quick flashes;
2. Select the system to which set the limit stops (the associated LED must be on);
–
3. Press the " " button to activate the limit stops setting.
4. Refer to the instructions for setting the limit stops relative to the digital motor. During the limit stops
adjustment the buttons of transmitter have the following functions:
" Λ "
" V "
<
"
>
"
-
"
5. The LED LD0 flashes quickly 5 times to confirm the set has been successful. The transmitter closes the
procedure;
6. Repeat from point 1) for a new limit stops setting.
Note:
• If the limit switches are set overlap, the corresponding LED flashes 11 times.
• If in the REF. 5471 are assigned two or more motors the limit stops setting is inhibited.
This procedure cancels all the settings in the transmitter memory returning it to the factory settings.
1. Press simultaneously the " Setting " and " Limit " buttons until LED LD flashes 5 times followed by 3
quick flashes;
2. Six flashes of the all LED LD confirm that the procedure has been successful.
If intermediate stopping points are set in systems controlled by transmitters Ref. 5471 and Ref. 5474,
when a brief impulse is sent the systems activated will reach the first stopping point in sequence .
To open or close completely the control must be held down for 4 sec.
Transmitters Ref. 5471 and Ref. 5474 run on a 3V battery type CR2450. To replace the battery on transmitters
follow the instructions shown in attachment "A".
Please note that the old battery cannot be disposed of with non-differentiated urban
waste but must be collected separately in accordance with the regulations set down by
the local authorities.
Setting Limit Stops
moves the system in Direction 1
moves the system in Direction 2
" moves the system with a step in Direction 1
moves the system with a step in Direction 2
"
" memorizes the position of the limit stop
Reset
Intermediate limit stops
Changing the battery
(Ref. 5471- 5474)
The LED LD0 starts flashing;
(Ref. 5471- 5474)
( Ref. 5471- 5474)
(Ref. 5471- 5474)
En 5
Z803 rA 13