Ref. 5474 R. F. Transmitter For 4 Systems; Operating; Assigning A System - Mottura 5471 Manual De Instrucciones, Uso Y Mantenimiento

Ref. 5474 R. F. Transmitter for 4 systems

LD1 LD2
Using the transmitter Ref. 5474 up to 4 systems can be controlled individually and/or simultaneously. Each
system is monitored throughout the various phases of its movement and its status is communicated to the user
by means of the LED associated with it.
When used for the first time (or if no system is assigned to the transmitter) LEDs LD1, LD2, LD3 and LD4
flash twice in sequence when any button is pressed (except " Setting " and " Limit ").
The factory settings are as follows:
<
➢ buttons " " and "
➢ buttons " Λ " and " V " activate the system;
➢ button " – " stops the system;
➢ button " Setting " activates the setting procedure;
➢ button " Limit " activates the setting of limit stops;
➢ LEDs LD1, LD2, LD3 and LD4 signal the status of the relative system (see "LED signals");
➢ LEDs LD and LD0 LED signals the information regarding the setting procedures.
Note: the first time any button is pressed after the transmitter turns itself off causes it to reactivate. The LED
associated with the last system moved comes on and at this point it will be possible to use the transmitter as
normal.
By means of the assigning procedure up to 4 systems can be associated with the transmitter.
1. Press button " Setting " until LED LD flashes 5 times followed by 3 quick flashes;
2. Press the R. F. button of the system you wish to associate until the respective LED comes on (refer to the
relative technical manual of system).
The system transmits its own identification code to the transmitter (5 quick flashes of the LED LD0 confirm that
the procedure has been successful).
The system is assigned to the first LED available. Any other systems assigned (repeating the procedure from
point 1) will be associated in sequence to the successive LEDs.
Assigning is not permitted:
➢ more than four different systems;
➢ the same system more than once;
on the same transmitter Ref. 5474.
LD0 LD3 LD4

Operating

>
" select the system to be activated;

Assigning a system

LD
Limit
En 3
Z803 rA
Setting
11