Kohler K-15840 Guia De Instalacion página 4

Nut
Union
Compression
Hot
Cold
2. Supply Connections
Install the sink (if needed) according to the sink manufacturer's
instructions.
Identify the supply connection type.
Connect the supply tubes to the handle valves, and the supply
stops. Left is hot, right is cold.
Tighten all connections.
3. Installation Checkout
Ensure that all connections are tight.
Remove the aerator (if spout is installed).
Open the drain.
Turn on the main water supply and check for leaks. Repair as
needed.
Open both hot and cold valves and run water through the spout
(if installed) for approximately one minute to remove debris.
Check for leaks. Turn the valves off.
Remove any debris from the aerator and reinstall (if spout is
installed).
1010459-2-B
Aerator
4 Kohler Co.