Publicidad
Idiomas disponibles
Idiomas disponibles
Fax +32 2 359 95 50
INITIAL OPERATION
When you use your appliance for the first time, pour fresh water into the water tank and switch
on the appliance (without coffee).
Once all the water has passed through, switch the appliance off and let it cool down. When it
is cold enough, repeat the process with fresh water. Repeat this process 3 times.
SETTING THE CLOCK
Connect your coffee maker to the mains supply and do not press any button.
Press the "program" button. The display will indicate "set".
Press the "hour" button until the correct hour is displayed.
Press the "minute" button until the correct minutes are displayed.
USING THE TIMER
Note: make sure you have put water in your coffee maker before setting the timer.
Follow steps 1-3 of the "preparation of coffee" section.
Press the "program" button twice. The "clock symbol" will be flashing on the display.
Pres the "hour" and "minute" buttons to set the time when you want your coffee maker to
start brewing coffee.
Press the "auto" button. The "clock symbol" will show on the display and the indicator on
the gauge will illuminate red.
When the programmed time is reached, your coffee maker will start brewing the coffee.
PREPARATION OF COFFEE
Open the lid of the water tank.
Using the glass carafe, pour the desired amount of water into the water tank. Make sure
not to overfill by respecting the maximum level indicated on the water tank (maximum 15
cups).
Put a filter in the filter holder and, using the provided scoop, add the desired quantity of
ground coffee in the filter.
Never forget to close the lid of the water tank and place the glass carafe on the warming
plate before switching on your coffee maker.
Press the "start/cancel" button to turn on the coffee maker. The pilot light of the switch will
be illuminated, indicating that your appliance works. A device allows you to keep coffee
warm for as long as the coffee maker is working and the jug is standing on the appliance.
When you remove the jug from the appliance, a non-drip valve will automatically operate
to stop any drops of coffee dripping onto the hotplate. Replacement of the carafe
automatically opens the non-drip valve and allows remaining coffee to filter through into
the jug. This is a temporary function (for example, to pour one cup of coffee), otherwise
there will be a water overflow.
Wait until the brewing process is finished and the filter has run empty before removing the
jug.
After the brew process is complete and the water has run through, the coffee maker
switches off automatically within 35 minutes!
Make sure that you never let an empty jug on the appliance.
DECALCIFICATION AND CLEANING
Before cleaning, turn off the appliance, unplug it and let it cool down.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
9
Assembly page 9/44
TKG CM 1050 T - 160613
Publicidad
