Adjustment Mode - LaserLiner Centurium 410S Manual De Instrucciones

Adjustment mode

1. Take the alignment of the rotary laser into account when
performing adjustment work. Always adjust all the axes.
2. Switch the device to adjustment mode:
Switch off the Centurium and, while pressing and holding the
auto/man button, switch it on again. Press and hold the ON/OFF
button until the X-axis or Y-axis LED starts to flash. You can then
release both buttons.
The X-axis LED flashes first in horizontal mode (X/Y axis). You can
switch between X and Y-axis with the tilt button on the rotary laser
or the remote control.
Only the Y-axis LED flashes in vertical mode (Z-axis).
3. Correcting the adjustment:
Using the Plus/Minus buttons on the rotary laser or remote control
you can move the laser away from its current position to the level of
reference point A2. The laser only changes its position by pressing the
buttons several times.
4. Completing the adjustment:
Cancel: Switch the rotary laser off (via the ON/OFF button) to
reject all adjustment settings and restore the previous
status.
Save: The new adjustment settings are saved by pressing
the positioning button (rotate to the right).
Positioning: The laser can be rotated by pressing the positioning
button (rotate to the left).
Überprüfen Sie regelmäßig die
Regularly check the adjustment before
Justierung vor dem Gebrauch, nach
! !
use, after transport and after extended
Transporten und langer Lagerung.
periods of storage. Always make sure
Kontrollieren Sie dabei immer alle
to control all axes.
Achsen.
Centurium
Z
Y
X- / Y- /
Z-Axis
X
25
GB