Camera Mode - LaserLiner ThermoSpot-Vision Manual De Instrucciones

Camera mode

9
After selecting camera mode, the live image recorded by the camera is shown on the display. Infrared
measurement is started by pressing the trigger. The following measured values and symbols are shown on
the display:
10
Images or video sequences of the measuring situation can be recorded during IR measurement.
Still image
1. Record
2a. Save image:
2b.
Cancel:
You can open, preview and delete recorded
images under "Gallery" (see Point 13).
!
Before recording image data or video sequences, check the storage medium to be used to store the
data. See Settings under Point 7.
16 GB
Camera mode
IR measurement active
IR measurement stop-
ped
Laser active
AT Ambient temperature
DP Dew point temperature
RH% Relative humidity
WB
Wet-bulb temperature
E
Emissivity coef cient
Recording images/videos
MIN
MAX
DIF
AVG
Value in
middle
Video
1. Record
2a.
Start recording:
2b. Cancel:
3.
Stop recording
IR measurement and laser are triggered automati-
cally during video recording. The recording status
is indicated by the recording symbol at the top left
of the display together with the recording time.
You can open, preview and delete recorded videos
under "Gallery" (see Point 13).
Alarm High enabled
Alarm High exceeded
Alarm Low enabled
Alarm Low exceeded
Min value
Max value
Differential value
(max-min)
Average value
Surface temperature