Operating Information - Telwin DRIVE 9000 Manual De Instrucciones

A-7. Starter charging mini USB input port.
A-8. 5V/2A USB output.
A-9. LED light.
A-10. Starter clamps output socket (ref.
A-2)
A-11. Internal
indicator LED.
A-12. ON/OFF switch for the charge level,
to control the output port (ref. A-6)
and the LED light.
3. INSTALLATION
POSITIONING THE STARTER
When using the starter, position it on a
horizontal, flat and stable surface.

4. OPERATING INFORMATION

4.1 How to use the starter:
always in the order given below!
Always prevent the black and red
clamps from touching each other or a
common cable!
- Make sure that the vehicle or boat to be
started is switched off (switch or ignition
key in the OFF position).
- Connect the red clamp POS. (+) to the
battery terminal POS. (+), then connect
the black clamp NEG. (-) to the vehicle
chassis or the battery terminal NEG. (-),
at a distance from the fuel pipe.
- Check that the Red LED seen in fig. A-3
is OFF; if this is not the case, carefully
check that the clamp polarities are
connected correctly and the clamps
are not short-circuited by common
conductive parts.
- Check that only the Green LED seen in
fig. A-3 is ON;
- If all the LEDs are OFF, a situation
that occurs when the vehicle battery is
too low, it is possible to force the start
operation by pressing and holding the
"BOOST" button seen in fig. A-4 for three
seconds until the Green LED comes on.
WARNING: failure to follow
these rules may compromise
the operating life of the
device:
- Turn the vehicle ignition to the start
position for no more than 3 seconds.
- If the vehicle or boat does not start,
wait at least 15 seconds before trying
again.
- If the vehicle or boat still does not
battery charge
WARNING:
these instructions
meticulously,
start, wait at least 2 minutes before
trying again.
After a successful start, with the engine
running, follow the sequence of instructions
below with great care:
status - Disconnect the black clamp (negative)
from the vehicle.
- Disconnect the red clamp (positive) from
the vehicle.
- Remove the starter cable connector from
the starter
- Replace the cables and the starter in
their seats inside the case.
It is highly recommended to recharge the
starter as soon as possible.
4.2 Using the starter as a power and/or
charging device:
follow - Insert the output cable terminal (fig. A-5)
into the appropriate USB port on the
and starter (fig. A-8);
- Press the ON button seen in figure A-12
once;
- Insert the other cable terminal into the
device to be powered;
4.3 Using the LED lights
- Press and hold the ON button (fig.
A-12) for a few seconds to enable the
continuous LED light function.
The press the button in the following
sequence:
- once to start the blinking light;
- twice to start the emergency signal;
- three times to switch the light OFF.
5. CHARGING
Important! To achieve maximum battery
performance, always charge before use,
then after every time it is used and, in
any case, at least every 3 months.
It is possible to charge the unit using the
relative cable (fig. A-5) connecting the mini
USB terminal to the starter charge socket
(fig. A-7) and the other terminal to a USB
output source (e.g. a computer) or to the
12V car cigarette lighter socket using the
adaptor seen in figure A-6.
Press the button seen in fig. A-12 once to
check whether the battery needs charging.
The LEDs seen in fig. A-11 indicate the
charge status of the battery, which light up
as the status increases:
- one LED only: low battery;
- all LEDs are on: fully charged battery.
- 5 -