LaserLiner EvolutionCross-Laser 8 Manual De Instrucciones página 16

If the unit is placed at an excessive angle (out of its 2,5° range),
!
the lasers will blink. Align the device using the adjustable feet (7)
or place on a more level surface.
Slope function up to max. 2,5°
4
Activation of the slope function deactivates the automatic sensor, Press the
H-slope button and hold it down for at least 3 seconds until the auto LED
starts to blink very rapidly. Motor-driven adjustment of the slope can now
be carried out. Hold the V1 or V2 button down continuously to adjust slope.
When the lasers blink, the maximum slope range has been reached. The
H-slope button (pressed briefly) is used to switch over between axes. The
slope function is deactivated by pressing the H-slope button again for at
least 3 seconds. Refer to the illustrations below.
TIP: Switch the required laser lines on before you activate the slope function.
For the slope function, laser lines are no longer aligned to the
!
horizontal or vertical plane. This is a specific peculiarity of adjusted
laser lines. To reinstate horizontal or vertical levelling, deactivate the
slope function. Do this by switching the device off then on again.
Horizontal levelling adjustment up to a max. of 2,5° (X, Y axis)
5
16
GB
Very rapid blinking: X axis adjustment.
One-second rate blinking: Y axis adjustment
(to a max. of 2.5°).
3 sec
(1 sec)