Taurus GST1600 Modo De Empleo página 9

to removing the calcium deposits that form over
time on the metal parts of the steamer. For
best performance from the Garment Steamer,
please decalcify the unit from time to time. The
frequency depends upon the hardness of the
water being used and how often you use the
steamer.
METHOD:
1. To decalcify, use a solution of 1/3 white vinegar
2/3 water in the water tank.
2. Plug the unit into electrical outlet. Wait until
the red light goes off then push the steam button,
Release the steam button, unplug from electrical
outlet, and allow to cool for 30 minutes.
- Repeat the above procedure as many times as
necessary until a normal steam rate returns,
usually 2 to 3 times. With each repeated cycle,
use a fresh solution of vinegar and water.
- Run one cycle of distilled water through the
unit at the completion of decalcification before
using the product again.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the electrical equipment and the mains
connection with a damp cloth and dry. DO
NOT IMMERSE IN WATER OR ANY OTHER
LIQUID.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.