Ingeteam INGEREV CITY Duo Manual De Instrucciones página 9

Firmware update of the INGEREV GARAGE Basic station via USB
5. Check that the charging station has power and that the key is in position 0.
6. Insert the USB drive in the USB port, located in the lower part of the unit. The unit will restart, the light
will flash white and it will return to the previous status after a few seconds.
7. Remove the USB drive from the station.
8. Connect the USB drive to the computer and check that the data has been downloaded to the ingeteam >
support folder to confirm that the process has been performed correctly.
CAUTION
If not data has been downloaded the update has not been performed correctly. In this case, carry out the
process described above again.
Firmware update
1. In the USB drive, delete the aba1020.bin file from the ingeteam > bootloader folder, as well as all the
files located in ingeteam > support.
2. Extract the .bin file for the updated firmware version into the ingeteam > firmware folder in the USB
drive.
3. Rename the file to aba1022.bin.
4. Safely remove the USB drive from the computer.
5. Check that the charging station has power and that the key is in position 0.
6. Insert the USB drive in the USB port, located in the lower part of the unit. The unit will restart, the light
will flash white and it will return to the previous status after a few seconds.
7. Remove the USB drive from the station.
8. Connect the USB drive to the computer and check that the updated firmware version is specified in the
version.txt file in ingeteam > support.
ABA2025IQM05_ - Firmware update
Ingeteam
EN
ES
FR
IT
9