Radio Operation; Clock Function; Power Source - König Electronic HAV-PR40 Manual De Instrucciones

Manual
ENGLISH
4 BAND RADIO WITH ALARM CLOCK
OPERATING INSTRUCTION:
AM/FM/SW1/SW2 4 band radio with alarm clock
1) Telescope antenna
2) Handle bar
3) AC socket
4) Battery compartment
5) Power indicator
6) LCD
7) Time set/light
8) Alarm set

POWER SOURCE:

Battery operation
1) Open the battery cover.
2) Insert 2 "D" size (UM-1 or equivalent) batteries into the battery
compartment, making sure that the batteries are installed with the
proper polarities (+ and -).
AC supply
1) Making sure the voltage selector is set to the correct position.
9) Alarm on/off
10) Hour
11) Min
12) Band switch
13) Tuning dial
14) Volume dial with power switch
15) Earphone jack
Connect the AC cord to the AC socket and the wall socket. The radio
is now ready to use.
2) To switch off the radio completely, pull the AC cord from the wall
socket.
To prevent possible damage to this radio:
Load new batteries with their polarities (+ and -) aligned correctly.
Do not apply heat to batteries, or internal short-circuit may occur.
•
If this radio is not to be used for a long period of time, remove all
•
batteries and store them in a cool and dry place.
Remove dead batteries immediately.
•
Do not use old and new batteries together. Do not use different type
•
of batteries
Battery life: If the sound becomes low or distorted, replace batteries
•
with new ones.

RADIO OPERATION:

1) Rotate the volume knob to turn the radio on and adjust it to desired
sound level.
2) Select the preferred frequency band (FM/AM/SW1/SW2) by sliding
the band switch.
3) Rotate the tuning knob to tune to the desired station. The display
shows the frequency.
4) Adjust the antenna (see antennas).
5) To switch off the radio, rotate the volume dial until a click is heard.

CLOCK FUNCTION:

1) Press and hold the TIME SET button, and press the HOUR button
until the correct hour is shown. Ensure that the AM/PM is set properly.
2) While holding the TIME SET button, press the MINUTE button until
the minute is shown.
TO SET THE ALARM TIME:
1) Press and hold the ALARM SET button, and a
the display to identify the alarm time. While holding the ALARM SET
will appear on