Safety And Installation - Bibby Scientific Techne SBL-1 Manual Del Operador

Please read all the information in this booklet before using the unit.
WarnIng
HIGH TEMPERATURES ARE DANGEROUS: they can cause serious burns to operators and ignite
combustible material.
Techne have taken great care in the design of these units to protect operators from hazards, but users
should pay attention to the following points:
• USE CARE AND WEAR PROTECTIVE GLOVES TO PROTECT HANDS.
• DO NOT put hot objects on or near combustible objects.
• DO NOT operate the unit close to inflammable liquids or gases.
• DO NOT place any liquid directly in your unit.
• At all times USE COMMON SENSE.
OperatOr SaFety
All users of Techne equipment must have available the relevant literature needed to ensure their safety.
It is important that only suitably trained personnel operate this equipment, in accordance with the
instructions contained in this manual and with general safety standards and procedures. If the equipment
is used in a manner not specified by Techne the protection provided by the equipment to the Operator
may be impaired.
All Techne units have been designed to conform to international safety requirements and are fitted with
an overtemperature cut-out. On some models, the cut-out is adjustable and should be set to suit the
application. On all other models the cut-out is preset to protect the unit.
If a safety problem should be encountered, switch off at the mains socket and remove the plug from the
supply.
InStaLLatIOn
1. All Techne units are supplied with a power cable. This may be integral or plug-in.
2. Before connecting the mains supply, check the voltage against the rating plate. The rating plate is
on the rear of the unit. Connect the mains cable to a suitable plug according to the table below.
note that the unit must be earthed to ensure proper electrical safety.
The fused plug supplied with the mains lead for the SBL-1 and SBL-2 for use in the UK is fitted
with the following value fuse to protect the cable: 13 AMP.
3. Place the unit on a suitable bench or flat workspace, or in a fume cupboard if required, ensuring
that the air inlet vents on the underside are free from obstruction.

SaFety anD InStaLLatIOn

Connections 220/240V
Live Brown
Neutral Blue
Earth Green/yellow
2
110/120V
Black
White
Green