Important - Sauder 427463 Instrucciones De Montaje

Step 16
IMPORTANT: You will need someone's help in this step.
å
Fasten the TOP (L) to the ENDS (A and B). Use ten BLACK 9/16" LARGE HEAD SCREWS (1S) through the LIFT TABLE
å
MECHANISMS (23M) and into the holes in the ENDS.
NOTE: Be careful when lining up the holes in the MECHANISMS with the holes in the ENDS as to not damage any parts.
å
You should start each SCREW a few turns before completely tightening any of them.
BLACK 9/16" LARGE HEAD SCREW
(10 used in this step)
This hole will be used
in the next step.
Page 20
1S
L
23M
B
427463
These four holes
must be here.
23M
This hole will be used
in the next step.
A
www.sauder.com/service