DeWalt DW476 Manual De Instrucciones página 25

• Mount the round handle (22) using the two
screws (23).
• Fit one screw in the top hole (7) and the other in
one of the side holes (8).
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Ensure all materials to be ground or cut
are secured in place.
• Apply only a gentle pressure to the tool.
Do not exert side pressure on the
grinding wheel or cutting disc.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
Prior to operation:
• Install the guard and appropriate disc or wheel.
Do not use excessively worn discs or wheels.
• Be sure the spacer and threaded flange are
mounted correctly.
• Make sure the disc or wheel rotates in the
direction of the arrows on the accessory and the
tool.
Switching on and off (fig. A)
The on/off-switch of your angle grinder is equipped
with an unlocking switch or a locking switch for
continuous operation.
(U.K. & France only) - On/off-switch (1) with
unlocking switch (2)
• To unlock the on/off-switch, slide the unlocking
switch towards you.
• To run the tool, press the on/off-switch.
• To stop the tool, release the on/off-switch.
On/off-switch (1) with locking switch (2a)
• To run the tool, press the on/off-switch. The tool
now runs in continuous operation.
• To stop the tool, press the locking switch briefly,
and release the on/off-switch.
Do not switch the tool on or off when
under load.
DW491 - Using the diamond guard DE8501
(option) (fig. C)
The diamond guard is used for cutting concrete and
masonry, when accurate cutting depth adjustment
or dust extraction are required.
• Mount the diamond guard as described above.
• Connect a dust extractor to the outlet (17).
• Set the cutting depth using the ruler knob in the
front plate (13).
• Observe the safety instructions applying
to diamond cutting discs.
• Use a suitable diamond cutting disc
(check the data of the manufacturer).
• The maximum rotation speed on the cutting
disc must not be lower than that of the tool.
• Do not use cutting discs with a diameter
exceeding 230 mm.
Fire hazard! Do not use the dust
extractor when cutting metal!
Make sure that the dust extractor used is
suitable for the material to be cut and the
Diamond guard can be connected.
DW491 - Using the round handle DE8502
(option) (fig. F)
The round handle provides greater convenience and
makes your tool very easy to handle.
• Mount the round handle as described above.
Consult your dealer for further information on the
appropriate accessories.
E N G L I S H
25