Package Contents; Description (Fig. A); Electrical Safety - DeWalt DW543 Manual De Instrucciones

breakage of parts and any other conditions that
may affect its operation. Have damaged guards
or other defective parts repaired or replaced as
instructed.
Do not use the tool if the switch is defective.
Have the switch replaced by an authorized
D WALT repair agent.
E
20 Have your tool repaired by an authorized
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.

Package contents

The package contains:
1 Medium Duty Demolition Hammer
1 Side handle
1 Tube of chisel lubricant
1 Chisel bit
1 Kitbox (K-models only)
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and understand
this manual prior to operation.

Description (fig. A)

Your D WALT Medium Duty Demolition Hammer has
E
been designed for professional chipping, chiselling
and demolition applications.
1 ON/OFF-switch with lock-on button (10)
2 Electronic impact power control dial
3 Power-ON indicator LED
4 Service indicator LED
5 Mode indicator lever
6 Tool holder for SDS-max
7 Collar
8 Side handle
9 Side handle clamp knob
10 Lock-on button
11 Switch handle cover
12 Lower service access cover
13 Upper service access cover
14 Gearbox access cover
15
®
accessories
Soft start feature
The soft start feature allows the speed to build up
more slowly, thus preventing the chisel or point from
"bouncing" around on the masonry when starting up.
Electronic impact control (fig. B)
The electronic impact control (2) offers the following
advantages:
- use of smaller accessories without risk of breakage
- chiselling light and brittle materials without
shattering
- optimal tool control for precise chiselling
Service and power-ON indicator LEDs (fig. B)
The red service indicator LED (4) lights up when the
carbon brushes are nearly worn out to indicate that
the tool needs servicing. After approx. 8 hours of
use the motor will automatically be shut off. The
carbon brushes are not user-serviceable. Take the
tool to an authorized D
The green power-ON indicator LED (3) lights up
when the tool is switched ON. If the indicator LED is
lit but the tool does not start, the electrical motor
may be defective. If the indicator LED does not light
up and the tool does not start, the ON/OFF-switch
or the mains cord may be defective.

Electrical safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 50144; therefore no
earth wire is required.
Mains plug replacement (U.K. & Ireland
only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
E N G L I S H
WALT repair agent.
E
en - 3