Installation Instructions; Safety Warnings; System Components; Technical Specifications - STEINEL 170 Serie Manual Del Usuario

Serie 170-190_10spr.qxd

Installation instructions

GB
Dear Customer,
Congratulations on purchasing your new STEINEL
SensorLight and thank you for the confidence you
have shown in us. You have chosen a high-quality
product that has been manufactured, tested and
packed with the greatest care.
Please familiarise yourself with these instructions
before attempting to install the SensorLight because
prolonged reliable and trouble-free operation will only
be ensured if it is fitted properly.
We hope your new STEINEL SensorLight will bring
you lasting pleasure.

System components

Wall mount
Sensor lens (can be removed and turned for
selecting the max. basic reach settings of
5 m or 12 m)
Twilight setting
Time setting
Brightness control / Watt-o-matic (dimming)
Mains connection
Decorative panel
Cover
Locking screw

Technical specifications

Output:
Voltage:
Angle of coverage:
Sensor reach:
Time setting:
Twilight setting:
Brightness control:
Manual override function:
Enclosure:
31.07.2008 12:35 Uhr
I Disconnect the power supply before attempting
I The electrical connection lead must be dead during
I Installing the SensorLight involves work on the
I Only set functions
The integrated infrared sensor is equipped with two
120° pyro sensors which detect the invisible heat
emitted by moving objects (people, animals etc.).
The heat detected is converted electronically into a
signal that switches the light on automatically. Heat is
not detected through obstacles, such as walls or
panes of glass. Heat radiation of this type will, there-
fore, not trigger the sensor. The two pyro sensors
have an angle of coverage of 180° with an angle of
aperture of 90°. The sensor lens can be removed and
turned. Consequently, two basic reach settings of
max. 5 or 12 metres can be preselected.
Important: The most reliable way of detecting motion
is to install the SensorLight in such a way that the
sensor is aimed across the direction in which a person
would walk and by ensuring that no obstacles (such
as trees and walls, for example) obstruct the line of
sensor vision.
100 watts max. (filament bulb, no energy-saving lamp)
230/240 V, 50/60 Hz
180° with 90° angle of aperture
basic setting 1: 5 m max.
basic setting 2: 12 m max. (factory setting)
+ precision adjustment from 1 to 12 m using clip-on shrouds
5 sec. – 15 min.
2 – 2000 lux
0 – 50% (Watt-o-matic)
selectable (4 hours) provided
switch is connected in mains supply lead
L 170/180 S: IP 43
L 190/191 S: IP 44
- 8 -
Seite 9

Safety warnings

any work on the unit.
installation. Therefore, switch off the power first
and check that the circuit is dead using a voltage
tester.
mains voltage supply. This work must therefore
be carried out professionally in accordance with
applicable national wiring regulations and electrical
operating conditions.
D A
( - VDE 0100, - ÖVE-EN 1,
, ,
Principle
- SEV 1000)
with the lens fitted.