GYS STARTPACK 12.24 CI Manual Del Usuario página 17

Translation of the original instructions
STARTPACK PRO 12.24 CI
1
3
5
Product
STARTPACK PRO 12.24
Regardless of how the STARTPACK PRO 12.24 is being used, always replace both batteries at the same
time.
To replace the batteries :
• Disconnect the booster from the mains beforehand.
Unscrew the back shell ( 1 - 8 screws) and remove it.
•
• Once the back panel is removed, the batteries are visible, one on top of the other (see picture).
• The batteries are maintained by a partition (striped area
the - terminal and at the + terminal.
• Start with the top battery. First completely unscrew the retaining wall 2 , then unscrew the two nuts on the - and
+ side of the battery 3 and remove it.
Once the first battery is removed, make sure to insulate the terminals to prevent any short circuit.
• Then, do the same with the bottom battery. Unscrew the partition 4 , then unscrew the two nuts used to connect
the battery to the STARTPACK 5 and remove the battery.
When putting new batteries, make sure to match the polarities of both batteries and STARTPACK
PRO 12.24 CI. Reassemble the batteries in the following order:
Reposition and tighten slightly the bottom partition 4 . Then insert the battery, screw it back on 5 and tighten
•
the partition completely. Do the same with the bottom battery. Position the partition first and tighten lightly 2 ,
insert the battery, screw it back 3 and tighten the partition completely. Finally screw the back shell 1 back on.
STARTPACK 12.24 CI / PRO 12.24 CI
2
4
Battery Type
PC950 Lead acid battery
Voltage (V) Capacity (Ah)
2 x 12 2 x 30
) and connected to the STARTPACK at two points: at
EN
3
5
Dimensions (cm) Battery ref
25 x 9,7 x 15,6 53135
17