Pc Troubleshooting - Thrustmaster ENZO FERRARI WIRELESS Manual De Instrucciones

PLAYING WITH TWO ENZO WIRELESS WHEELS SIMULTANEOUSLY
Enzo Wireless whee lallows up to 2 players to play at once, thanks to the channel selector switches
located on the side of the receiver and on the underside of the wheel. Channel A is the default channel,
and must always be used by one of the two players. For multiplayer gaming, each player must use a
different channel by configuring both his or her receiver and wheel to that channel.
Repeat steps above for the second wheel by setting the channel selector switches
the RF base station to the B position.
Important:
• Up to two Enzo Wireless wheels may be used simultaneously. Please note that each wheel must be
equipped with its own RF base station.
• This device is only guaranteed to be compatible with other Enzo Wireless wheels.
SELECTING "SEPARATE" (3-AXIS) OR "COMBINED" (2-AXIS) ACCELERATION/BRAKING MODE
By default, the Enzo Wireless 's accelerating and brake controls operate in "combined" 2 -axis mode (red
diode), i.e with brake and gas pedals operating on the same axis. An increasing number of new
generation racing games offer "seperate" (3-axis) mode which can be activated in the game's controller
options section. 3-axis mode considerably improves driving precision in races.
To activate this mode on your wireless wheel, you must download the patch named Wheelpatch.exe
from the www.thrustmaster.com
your PC , simply press the 9 + 10 button simultaneously on your wheel. The Mode LED will blink red.
When Playing games that do not provide 3 axis-mode support, you must revert to the standard 2-axis
mode (otherwise , your wheel may not function correctly when playing).

PC TROUBLESHOOTING

My wheel is not detected by my computer
- unplug the USB connector and then plug it back in again.
My wheel is detected by my computer but doesn't work in the game .
- Access your game's options to configure your wheel. Please refer to your game's manual
for further information
My Wheel Doesn't work correctly or appears to be incorrectly calibrated:
- Exit the game, then disconnect your wheel for your PC's USB connector and plug it back in
again.
Note: Do not turn your wheel or press any of its buttons after reconnecting it to your PC!
- install the patch named Wheelpatch.exe on your PC card and try to reconfigure your wheel in your
game's Controller options (if your wheel's 3-axis mode seems incompatible, try activating the 2-axis
mode).
website (select Support then Download). After installing the patch on
4/6
on the wheel and