Safety 1st Advanced Solutions IH198 Guía Para El Usuario

One-Way Nasal Aspirator
One-Way Nasal Aspirator
User's Guide IH198
Thank you for purchasing this Advanced Solutions™ product. We're proud to be your choice to help you keep
your child healthy and safe. Please read these instructions completely before using this product.
To Use
1.
Hold baby upright and grasp aspirator as shown
(Figure A). Gently place aspirator tip in nostril, angled
so that it does not point directly toward center of nostril.
2.
Keeping tip in the nostril, pump with thumb on bottom
of bulb (6+ times in rapid succession) to create
suction. Air flows into tip and out vent (Figure C),
while mucus collects just inside the tip.
3.
When aspiration is complete, remove tip from nostril.
Repeat in other nostril.
4.
Clean aspirator after use.
©2013 Cosco Management, Inc. All Rights Reserved.
www.djgusa.com (800) 544-1108 www.safety1st.com
Made in CHINA. Styles and colors may vary.
Distributed by Dorel Juvenile Group, Inc., 2525 State St., Columbus, IN 47201-7494
Dorel Distribution Canada, 873 Hodge, St. Laurent, QC H4N 2B1
02/25/13 4358-6052A
A
B
C
CAUTION:
the nostril. Wash and dry thoroughly before first use and
after each use. NEVER use in baby's mouth or ears. When
storing, keep away from heat and bright light. This product is
not a toy. DO NOT allow children to play with it.
To Clean
D
1.
Separate bulb into three parts: top of bulb, bottom of bulb and
silicone tip (Figures D and E). DO NOT attempt to remove valves.
2.
Wash all parts in warm soapy water and rinse thoroughly. Run
warm water through the valves in the same direction as air flow
E
(arrows in Figure C). Avoid using abrasive pads or cleansers.
3.
Sterilize silicone tip (optional): Microwave 90 seconds on high.
Tip will be hot. Allow to cool completely before touching or using
it. DO NOT put other aspirator parts in microwave.
4.
Air dry, then be sure to install tip completely during reassembly.
NEVER push the aspirator too far into