Adjusting Handset Receiver (Earpiece) Voice Volume; Adjusting Handset Speakerphone Voice Volume; Placing A Call On Hold; Mute - EnGenius EP800 Manual De Instrucciones

To end a telephone or intercom call, press
charger cradle.

Adjusting Handset Receiver (Earpiece) Voice Volume

1. Voice volume can only be adjusted during a call.
2. There are 6 levels of volume selections. Use
key to adjust
3. The new setting remains effective for all future calls
until changed.

Adjusting Handset Speakerphone Voice Volume

1. Voice volume can only be adjusted during a call (in
speakerphone mode).
2. There are 6 levels of volume selections. Use
key to adjust
3. The new setting remains effective for all future calls
until changed.

Placing a Call On Hold

1. When a call is in progress, it can be put on hold by
pressing the (Left) soft key and followed by
OPTION
"＊".
2. To return to the conversation, press
soft key
Notes:
1. The call being placed on hold can be "un-hold" by the handset
that puts it on hold. But if the handset press
standby, then other handsets can press
key, or place handset into
or
or
UNHOLD (Left)
key to go back
to pick this held
~33~
call.
2. Handset LCD displays a call is being on hold. An alert tone
(double beep) every 30 seconds will remind the handset that a
call is being on hold.
3. If the operation (e.g., call transfer) after putting a call on-hold
fails, the held call may be dropped.

Mute

1. After a link is established, you can press
soft key to mute the handset microphone.
2. When mute is active, the other end will not hear your
voice, but still can speak to you.
3. To leave the mute state, press
only for the current call.

Do Not Disturb (Silent Ring)

1. Enter the key sequence MENU-3-1, then select "Off".
Press SELECT (Left) soft key to confirm your choice.
This will turn off the ringer until it is turn on again from
the menu.
Re: When setting the ringer "Off", the standby screen
will show "Ringer off".
2. For temporary silencing the ringer when an incoming
call arrives, press SILENT (Left) soft key.

Key Guard

1. To prevent accidental dialing, you can press
(Right) soft key, then press"1" to select KeyGuard
option. The handset keypad is locked. No key entry is
accepted.
MUTE (Left)
UNMUTE (Left) soft key. Mute is effective
MENU
~34~