Adjusting Handset Receiver (Earpiece) Voice Volume; Adjusting Handset Speakerphone Voice Volume; Adjusting Base Speakerphone Voice Volume; Placing A Call On Hold - EnGenius FreeStyl 1 Manual De Instrucciones

charger cradle.
B. from Base
To end a telephone call, press
key.

Adjusting Handset Receiver (Earpiece) Voice Volume

1. Voice volume can only be adjusted during a call.
2. There are 6 levels of volume selections. Default = 3.
Use or key to adjust
3. The new setting remains effective for all future calls
until changed.

Adjusting Handset Speakerphone Voice Volume

1. Voice volume can only be adjusted during a call.
2. There are 6 levels of volume selections. Default = 3.
Use or key to adjust
3. The new setting remains effective for all future calls
until changed.

Adjusting Base Speakerphone Voice Volume

1. Voice volume can only be adjusted during a call.
2. There are 6 levels of volume selections. Default = 4. Use
key to adjust
3. The new setting remains effective for all future calls until changed.
key. To end a intercom call, press
or
~33~

Placing a Call On Hold

1. When a call is in progress, it can be put on hold by
pressing the key.
2. To return to the conversation, press
soft key
Notes:
1. The call being placed on hold can be "un-hold" by the handset
that puts it on hold. But if the handset press
standby, then other handsets can press
this held call (If press
call).
2. Handset LCD displays a call is being on hold. An alert tone
(double beep) every 30 seconds will remind the handset that a
call is being on hold.
3. If the operation (e.g., call transfer) after putting a call on-hold
fails, the held call may be dropped.

Mute

1. After a link is established, you can press
soft key to mute the handset microphone.
2. When mute is active, the other end will not hear your
voice, but still can speak to you.
3. To leave the mute state, press
key. Mute is effective only for the current call.

Do Not Disturb (Silent Ring)

1. Enter the key sequence MENU-3-1, then select "Off".
Press SELECT (Left) to confirm your choice. This will
turn off the ringer until it is turn on again from the
menu.
Re: When setting the ringer "Off", the standby screen
will show "Ringer off".
UNHOLD (Left)
key to go back
or to pick
on base, it can also pick up this held
MUTE (Left)
UNMUTE (Left) soft
~34~