Braun Clean&Charge 5301 Manual De Instrucciones página 7

Braun Clean&Charge has been developed
to automatically clean and charge your
shaver. It also serves as a storage unit.
For peak performance of your shaver, clean
it daily in the Clean&Charge.
During the automated cleaning process,
the shaver is switched on and off at inter-
vals to obtain best cleaning results. Since
the specially formulated cleaning fluid also
contains a small amount of oil, the
cleaning procedure also fulfills the lubri-
cation needs of your shaver.
Important
• Only use the power supply cord set supplied
with the shaver.
• In order to avoid any leakage of the clean-
ing fluid, place the appliance on a flat,
stable surface. Be careful not to tip, move
suddenly or transport in any way if a cleaning
cartridge is installed.
• Do not place the appliance in a mirror
cabinet, nor store it over radiators, nor
place it on polished or laquered surfaces.
Do not expose to direct sunlight.
• The appliance contains highly
flammable liquid. Keep it away
from sources of ignition.
No smoking. Keep out of reach of
children. Do not refill cartridge. Use only
original Braun refill cartridge.
• When cleaning the shaver, its protection cap
should be removed.
A Description
1 Lift button for cartridge exchange
2 Contact bow
3 Release button
4 Operation mode selector
5 «clean» light:
cleaning process indicator
6 «charge» light:
charging process indicator
7 «cartridge» light:
cartridge replacement indicator
8 Cleaning cartridge
8
Technical specifications
• Power consumption:
3 W when cleaning
7 W when charging
• Power supply: 100 -240 V 2/ 50 or 60 Hz
(automatic adaptation)
• Input voltage: 12 V
B Before using Clean&Charge
Only applies for rechargeable shavers:
For the first charge of the shaver, connect
the power supply cord set directly to the
shaver, charge it for 4 hours and shave at
least once.
Only then, can the shaver be cleaned or
recharged in the Clean&Charge.
If the rechargeable battery is discharged,
select the combined «clean + charge»
program rather than the «clean» program
alone.
Installing the cartridge
• Press the lift button (1) to open the
housing.
• Hold the cartridge down on a flat, stable
surface (e.g. table).
Carefully remove the lid from the cartridge.
Slide the cartridge into the base as far as it
will go.
• Slowly close the housing by pushing it
down until it locks.
Replacing the cartridge
After having pressed the lift button to
open the housing, wait for a few seconds
before removing the used cartridge.
Before discarding the used cartridge, make
sure to close the openings using the lid of the
new cartridge, since the used cartridge will
contain contaminated cleaning solution.