Braun Clean&Charge 5301 Manual De Instrucciones página 8

Ocultar thumbs Ver también para Clean&Charge 5301:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

C Operating your Clean&Charge
Use the cord from your shaver and plug it
into the Clean&Charge and then into a main
outlet.
Open the contact bow (2) by pressing the
release button (3). After shaving, switch
the shaver off and place it upside down
into the Clean&Charge (without having
released the shaver foil).
Select the operation mode by toggling
with the mode selector (4):
clean
clean + charge (about 75 min)
charge
The corresponding lights will come on.
(With cord shavers, only the «clean» function
can be selected.)
Slide down the contact bow to connect
the shaver and to start the selected program.
If no program is selected, the default
function «clean» will be started.
(Shaver model 7570 only: The LCD display
shows the remaining time of the running
program in 5-minute steps.)
Do not interrupt a running program, as it
leaves the shaver wet and not fit for use. If
interruption is needed nonetheless, press the
release button.
After a program has finished, the
corresponding light will go out.
Prior to the next shave, press the release
button to release the shaver.
When the «cartridge» light starts flashing,
the remaining fluid in the cartridge is
sufficient for approximately 5 more cleaning
cycles. After these 5 cycles, the cleaning
performance will be reduced and the
cartridge has to be replaced.
(about 15 min)
(about 60 min)
When the «cartridge» light illuminates con-
stantly, the cleaning function is locked and
a new cartridge has to be installed.
Only then, the next cleaning cycle can be
started.
A cleaning cartridge should be sufficient
for about 30 cleaning cycles. With daily
use, the cleaning cartridge should be
replaced approx. every 4 weeks.
The hygienic cleaning solution cartridge
contains alcohol which, once opened,
will naturally evaporate slowly into the
surrounding air. Each cartridge, if not used
daily, should be replaced after approximately
8 weeks.
Do not leave the appliance plugged-in
without the shaver inserted.
Clean the housing from time to time with
a damp cloth, especially the opening
where the shaver rests.
D Accessories
Refill cartridge (double pack) CCR 2,
(#5331)
Subject to change without notice.
9

Publicidad

Tabla de contenido
loading

Tabla de contenido