Black+Decker MTNF9 Manual De Instrucciones página 5

Do not operate the inflator when the engine is
u
running.
Operate only with the accessories included
u
or those rated for 160 PSI / 11.03 BAR / 1103
KPA. or higher. The use of any accessory not
recommended for use with this tool could be
hazardous.
Do not play with the tool. High pressure air is
u
dangerous. Do not direct air-flow at yourself or
others.
The inflator can become hot during use. Allow
u
inflator to cool for 30 minutes before storing
away.
Never carry the inflator by the hose.
u
Do not direct the nozzle or hose at animals or
u
bystanders
Store the inflator out of reach of small children.
u
The gauge is intended as a guide only. Tyre
u
pressures should be regularly checked with a
certified gauge.
Before use, check the power supply cord for
u
signs of damage, ageing and wear.
The intended use is described in this instruc-
u
tion manual. The use of any accessory or
attachment or performance of any operation
with this tool other than those recommended
in this instruction manual may present a risk of
personal injury and/or damage to property.
(Original instructions)
Features (fig. A)
Tool shown is MT143. Other tools are available for
use with this tool head.
This tool includes some or all of the following
features.
10. Inflator head
11. Air hose
12. Valve adaptor
13. Pressure guage
14. Accessory storage compartment
15. Needle nozzle
16. Beach ball nozzle
Assembly
Warning! Before assembly, remove the battery
from the tool.
Fitting the valve adaptor to a tyre valve or
nozzle (fig. B)
Position the lever (17) of the valve adaptor (12)
u
in the striaght up position (shown).
Push the valve adaptor (12) over the required
u
nozzle (or over the valve of a bicycle or car
tyre).
When the valve adaptor (12) is down as far as
u
it will go, lock it in place by pushing the lever
(17) down towards the air hose (2).
ENGLISH
5