Publicidad
English
Safety Instructions
Only for use in rooms.
All electrical equipment in the water must be disconnected from
the mains during care and maintenance work.
The connecting line of this device can not be replaced. When the
line is damaged, the device must no longer be used. Never carry
the pump by the cable; do not bend the cable.
geprüfte
Sicherheit
Model: see type plate on pump housing
Function
A
Pump
Filter module with cartridge
Diffusor
bottom
Closing slide
Installation
B
Clip clamping plug into apertures in retaining plate. Install suction
pads. If preferred, the retaining plate can be attached to one side
of the pump, permitting the filter to be installed facing in any di-
rection.
C / D Screw in either discharge connection (C) or diffusor (D) as required.
Discharge connection: used fo good water surface movement.
Height of filter is regulated by means of perforated locking device
on mounting support.
Diffusor: This is preferable for aquariums without plants. The oxy-
gen supply can be regulated by the air regulating valve.
Open filter shutter and secure filter in aquarium (for minimum im-
mersion depth, see diagram C). Connect electrical plug to initiate
filter operation.
Putting into operation
E
Modules can be easily separated by the application of light pres-
sure on the locking points at the sides.
The cartridges (order no. 2615480) should be washed out and re-
placed alternately to prevent the biological filtering process from
being interrupted. This is necessary when the pump performance
becomes noticeably reduced. CAUTION: Make sure you close
the filter shutter before removing the filter.
F
The filtering area can be changed individually by reducing or ex-
tending the modules. (Accessory item – order no. 7478860, filter
module with filter cartridge.)
Universal centrifugal pump 1048
³ Motor · Threaded adaptor » Clamping ring ¿ Pump parts
A
Maintenance and servicing
B / C Remove power supply plug. Release clamping ring (B) and remove
pump parts as per drawing (A). Clean pump thoroughly with EHEIM
brush set (order no. 4009550) (C). Clean pump under running wa-
ter, then reassemble in correct sequence. CAUTION: The pump
has not to run dry.
The product is qualified in accordance with the respective
national regulation and guidelines and meets EC standards.
Internal filter 2048
Air regulating valve
Clamping plug
Discharge connection
Retaining plate
Filter
Suction cup.
Publicidad
