EHEIM aquaball 2206 Manual Del Usuario página 10

The base model of this modular internal filter ensures the
mechanical cleaning of the aquarium water with permanent
circulation, specific surface movement and controllable oxy-
gen supply.
Thanks to the pump head that rotates in three dimensions, it is
possible to adjust the outflow direction. The power regulator al-
lows the flow rate to be adjusted to the desired setting and,
thanks to the diffuser, it is also possible to regulate the amount
of air added to the water. The practical holder allows the filter
to be positioned inside the aquarium and removed with ease.
Installation
B Attach diffuser with air hose and air regulating valve to
the connection adapter of the power regulator.
C Fasten the holder with the suction cups to the inside of
the aquarium glass and clip the filter into place.
Putting into operation
D Insert the filter such that the pump head is positioned
just beneath the surface of the water. Adjust the pump
head to the required outflow area and surface angle.
E By turning the power regulator, it is possible to infinite-
ly adjust the pump power to the required setting. The dif-
fuser's air regulating valve is used to regulate the a-
mount of oxygen added to the water. Important: The dif-
fuser power decreases in line with the degree of soiling.
Cleaning
F Disconnect the filter from the mains and, subsequently,
by tilting it forwards, pull it out of the holder.
G Remove the filter base, take out the filter cartridge and
rinse out under running water or replace with a new car-
tridge. Clean all the filter components and subsequently
reassemble.
Maintenance
H The pump head is removed by pulling the pump out of
its holding housing.