Machine Specifications; Delivery Scope; Intended Use; Ce Declaration Of Conformity - Amann Girrbach ceramill 181400 Manual Del Usuario

M A C H I N E S P E C I F I C A T I O N S
4

Machine Specifications

E N 4.1

Delivery Scope

_ Milling machine
_ Mains cable
_ Wireless barcode scanner
_ Milled-out test specimens in packaging
_ Network cable (5 m)
_ USB cable
_ Service set for collet
_ Torque screwdriver for blank holder
_ Collet tool
_ 3 × 125 ml coolant/lubricant
_ Calibration body
_ Calibration pin
_ 4 × Filter (1 of which mounted in tank)
_ Tank key
_ Maintenance oil for axes
_ Grinding-point set consisting of grinding points
with 2.0 mm (mounted in collet), 1.0 mm and
0.4 mm
▷ After unpacking, check the machine for com-
pleteness and possible transport damages.
Please claim any transport damages immedi-
ately with your supplier.
4.2

Intended Use

The milling machine is a PC-controlled milling and
grinding machine for the fabrication of dentures
by means of wet processing of blanks made of
glass ceramics, plastics or zirconium oxide.
Using blanks and tools not approved by the manu-
facturer can damage the machine and make the
product unusable. For such cases, the manufac-
turer shall assume no liability whatsoever.
Unauthorised modifications/alterations of the
machine shall also void the warranty.
28
4.3

CE Declaration of Conformity

This product (181400 – Motion DRS) was designed
and manufactured based on careful selection of
the harmonised standards to be observed, as well
as additional technical specifications. It thus cor-
responds with the state-of-the-art and ensures
maximum safety.
In terms of design and performance, this product
complies with the European Directives and the
supplementary national requirements. Conform-
ity has been confirmed with the CE marking.
EC Directives
_ 2011/65/EU:2011-06-08, RoHS II Directive
_ 2006/42/EC:2006-05-17, Machinery Directive
_ 2014/30/EU:2014-02-26, EMV Directive
Applied harmonised standards
_ DIN EN ISO 12100 Corrigendum 1: 2013-08
_ DIN EN 63000:2019-05
_ DIN EN 55011:2018-05
_ DIN EN 61010-1:2020-03
_ DIN EN ISO 16090-1:2019-12
_ DIN EN 61000-4-4:2013-04
_ DIN EN 61000-4-5:2019-03
The product's declaration of conformity is availa-
ble upon request from the manufacturer.