Amann Girrbach ceramill 181400 Manual Del Usuario página 42

S E R V I C E ( C L E A N I N G A N D M A I N T E N A N C E )
8.3.3 Cleaning the tank and replacing cool-
ant/lubricant (C/L)
E N
For cleaning the tank and replacing the cool-
ant/lubricant, a new filter, 125 ml of coolant/lubri-
cant and the tank key are required.
CAUTION:
Health hazards are possible through improper
handling of C/L!
▷ Use only C/L recommended by the manufac-
turer!
▷ Observe the safety instructions and handling
regulations for C/L!
Dispose of the C/L in accordance with the
applicable regulations and laws.
Perform the tank cleaning over a washba-
sin/sink.
The water for the coolant/lubricant must
have drinking-water quality. The optimal
hardness range is between 10 - 20 °dH
(corresponds to 1.8 - 3.6 mmol total hard-
ness per litre). If the hardness is far
beyond this range, we recommend the
addition of distilled water. For grinding
glass-ceramic materials, it is generally rec-
ommended to use distilled water.
▷ Press
the wizard's instructions.
42
Clean coolant tank button
8.3.4 Calibrating the machine
For calibration of the machine, the provided cali-
bration body, the torque wrench and the calibra-
tion pin are required.
Faulty calibration possible!
▷ Clean the machine thoroughly prior to cali-
bration (see section 8.3.1).
▷ Press
the wizard's instructions.
and follow
NOTE:
Calibrate machine button
and follow