Publicidad
Idiomas disponibles
Idiomas disponibles
Removing the Air Deflector Brackets (30'' Dual Fuel
Models only)
When installing a Low Back the air deflector brackets must
be removed. These brackets are to only be used with the
Flush Island Trim Assembly.
3. To remove the brackets, remove the screws that
secure the brackets to the back of the range. Discard
the brackets.
English 2
Installing the Lowback
4. Align the back panel of the new accessory with the
flanges on the range side panels right and left rear
corners. The backguard is inserted inside the guide
channels on the back of the range.
5. Make sure the backguard's front face is outside the
flange on the front side of the range.
6. Re-install screws removed in Steps 1 and 2.
9001078744 • Rev. A • 5U06Y7 • © BSH Home Appliances Corporation, 05/15
Publicidad
