3M Clean-Trace Manual Del Usuario página 14

(English)
As each digit is selected the relevant digit box is replaced with a *
continue until all digits are entered, then press Select.
If the Password has been entered incorrectly an INCORRECT PASSWORD message will be displayed.
Press the oK button and key in the password again as shown above.
If user Passwords are not set up, the previous three steps will be omitted.
Provided that the password has been entered correctly the PROGRAM MODE menu will display the current list of sample plans as shown below. use
the navigation buttons to highlight the required sample plan and press Select.
At this point it is possible to use the 3M clean-trace nG Luminometer to perform a new series of tests for the selected sample plan, or to perform
retests on existing stored results which are shown in date order on the screen.
12