- Insert the special SDS-plus® screwdriving
adaptor for use with hexagonal screwdriver
bits (D25112(C)K/D25113K/D25213K).
- Replace the tool holder with the chuck
(D25114K).
● Insert the appropriate screwdriver bit.
When driving slotted head screws always use
bits with a finder sleeve.
● Gently press the variable speed switch (1) to
prevent damage to the screw head. In reverse
(LH) rotation the tool speed is automatically
reduced for easy screw removal.
● When the screw is flush with the workpiece,
release the variable speed switch to prevent the
screw head from penetrating into the workpiece.
D25113K/D25114K/D25213K -
Chipping and chiselling (fig. A)
● Set the mode selector switch (4) to the
"hammering only" position.
● Insert the appropriate chisel and rotate it by
hand to lock it into one of 51 positions.
● Adjust the side handle (9) as required.
● Switch on the tool and start working.
● Always switch off the tool when work is finished
and before unplugging.
● Do not use this tool to mix or pump
easily combustible or explosive fluids
(benzine, alcohol, etc.).
● Do not mix or stir inflammable liquids
labelled accordingly.
Optional accessories
Various types of SDS-plus
are available as an option.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D
WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular
cleaning.
● This machine is not user-serviceable. Take the
tool to an authorised D
approximately 40 hours of use.
drill bits and chisels
®
WALT repair agent after
E
If problems occur before this time contact an
authorised D
WALT repair agent.
E
● The tool will automatically switch off when the
carbon brushes are worn.
A
Lubrication
Your power tool requires no additional lubrication.
Accessories and attachments used must be
regularly lubricated around the SDS-plus
S
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Never use solvents or other harsh
@
chemicals for cleaning the non-metallic
parts of the tool. These chemicals may
weaken the plastic materials used in
these parts. Use a cloth dampened only
with water and mild soap.
Protecting the environment
Separate collection. This product
Z
must not be disposed of with normal
household waste.
Should you find one day that your D
needs replacement, or if it is of no further use to
you, do not dispose of it with household waste.
Make this product available for separate collection.
Separate collection of used products
z
and packaging allows materials to
be recycled and used again. Re-use
of recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
Local regulations may provide for separate
collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
E N G L I S H
fitment.
®
WALT product
E
35