Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
E N G L I S H
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
machine (see technical data).
The minimum conductor size is 1.5 mm
When using a cable reel, always unwind the cable
completely.
Also refer to the table below.
Conductor size (mm
)
2
0.75
1.00
1.50
2.50
4.00
7.5
Voltage
115
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Assembly and adjustment
Prior to assembly and adjustment
@
always unplug the tool.
Selecting the operating mode (fig. B1 & B2)
D25112(C)K (fig. B1)
The tool can be used in the following operating
modes:
Rotary drilling: for screwdriving and for
drilling into steel, wood and plastics
Hammer drilling: for concrete and
masonry drilling operations.
32
.
2
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
15
25
30
45
Amperes Cable rating (Amperes)
6
6
6
6
6
6
6
6
15
6
6
10
15
20
10
10
15
20
20
15
15
20
25
25
20
20
25
-
6
6
6
6
6
6
6
6
6
6
6
6
10
10
10
10
10
15
15
15
15
15
20
20
20
20
20
25
D25113K/D25114K/D25213K (fig. B2)
The tool can be used in the following operating
modes:
60
6
10
● To select the operating mode, press the safety
15
lock (5) and rotate the mode selector switch (4)
20
until it points to the symbol of the required mode.
25
● Release the safety lock and check that the
-
mode selector switch is locked in place.
-
-
6
6
@
6
6
15
15
Indexing the chisel position
20
The chisel can be indexed and locked into
-
51 different positions.
● Rotate the mode selector switch (4) until it
points to the "bit rotation" position.
● Rotate the chisel in the desired position.
● Set the mode selector switch (4) to the
"hammering only" position.
● Twist the chisel until it locks in position.
Inserting and removing SDS-plus
(fig. C)
This tool uses SDS-plus
inset in fig. C for a cross-section of an SDS-plus
bit shank).
We recommend to use professional accessories
only.
● Clean and grease the bit shank.
● Insert the bit shank into the tool holder (6).
● Push the bit down and turn it slightly until it fits
into the slots.
Rotary drilling: for screwdriving and for
drilling into steel, wood and plastics
Hammer drilling: for concrete and
masonry drilling operations.
Hammering only: for light chipping,
chiselling and demolition applications.
In this mode the tool can also be used
as a lever to free a jammed drill bit.
Bit rotation: non-working position used
only to rotate a flat chisel into the
desired position.
Do not select the operating mode when
the tool is running.
accessories (refer to the
®
accessories
®
®
Publicidad
Tabla de contenido
