Guard Function; Saw Blades - Black and Decker MTTS7 Manual De Instrucciones

g. Use extra caution when sawing into
existing walls or other blind areas. The
protruding blade may cut objects that can
cause kickback.
Safety instructions for circular saws with
outer or inner pendulum guards and with
tow guard

Guard function

a. Check guard for proper closing before each
use. Do not operate the saw if guarddoes
not move freely and enclose the blade
instantly. Never clamp or tie the guard so
that the blade is exposed. If saw is
accidentally dropped, guard may be bent.
Check to make sure that guard moves freely
and does not touch the blade or any other part,
in all angles and depths of cut.
b. Check the operation and condition of the
guard return spring. If the guard and the
spring are not operating properly, they
must be serviced before use. Guard may
operate sluggishly due to damaged parts,
gummy deposits, or a build-up of debris.
(Original instructions)
c. Assure that the base plate of the saw will
not shift while performing the "plunge cut"
when the blade bevel setting is not at 90°.
Blade shifting sideways will cause binding and
likely kick back.
d. Always observe that the guard is covering
the blade before placing saw down on
bench or floor. An unprotected, coasting blade
will cause the saw to walk backwards, cutting
whatever is in its path. Be aware of the time it
takes for the blade to stop after switch is
released.

Saw blades

Do not use blades of larger or smaller diameter
u
than recommended. For the proper blade
rating refer to the technical data. Use only the
blades specified in this manual, complying with
EN 847-1.
Never use abrasive wheels.
u
Features (fig. A)
Tool shown is MT143. Other tools are available for
use with this tool head.
This tool includes some or all of the following
features.
10. Trimsaw head
11. Lock off button
12. Spindle lock
ENGLISH
7