Black and Decker MTTS7 Manual De Instrucciones página 8

ENGLISH
13. Shoe
14. Upper guard
15. Lower guard
16. Guard retracting lever
17. Dust extraction outlet
18. Hex wrench
Assembly
Warning! Before assembly, remove the battery
from the tool.
Fitting and removing a saw blade (fig. A
& B)
Lock the tool by setting the forward/reverse
u
slider (2) to the centre position.
Press and hold the spindle lock (12). Using the
u
hex wrench (17) provided, remove the blade
bolt (18) by turning it clockwise.
Remove the outer clamping washer (19),
u
ensure that the inner clamping washer (20)
remains in place on the spindle (21).
Retract the lower guard (15) using the guard
u
retracting lever (16) and place the saw blade
(22) onto the inner clamping washer (20),
making sure that the arrow on the blade points
in the same direction as the arrow on the lower
guard.
Fit the outer clamping washer (19) onto the
u
spindle (21).
8
(Original instructions)
Fit the blade bolt (18) into the spindle(21) by
u
turning it anti-clockwise.
Press and hold the spindle lock (12). Using the
u
hex wrench (17) provided, tighten the blade
bolt (18) by turning it anti-clockwise.
Warning! Never engage the spindle lock while the
saw is running, or engage in an effort to stop the
tool. Never turn the tool on while the spindle lock is
engaged. Serious damage to your saw will result..
Warning! Ensure that you blade is correctly fitted.
Using the hex wrench (17) provided turn the
spindle anti-clockwise and ensure that the blade
does not make contact with the guard before start-
ing the tool.
Use
Warning! Let the tool work at its own pace. Do not
overload.
Sawing
Note: Ensure the forward reverse slider (2) is not
in the locked position.
To switch the tool on, lift the lock off button
u
(11) then press the variable speed switch (1).
The tool speed depends on how far you press
the switch.
Release the lock off button.
u
To switch the tool off, release the variable
u
speed switch.