Kathrein UFO 356/TP Manual De Instrucciones página 15

The main menu display when a channel unit is switched off is shown below:
Twin I
Inp. K10
∗
Outp. S21
6.900 MS/s
Main menu Twin I (switched off)
4 Selecting the output symbol rate and QAM stages
4.1 Setting the output symbol rate
Twin I
Inp. K10
Outp. S21
6.900 MS/s
The output symbol rate can be determined independently for both channels. It can be set continuously in 0.1 MS/s steps from
1.5 MS/s to 7.15 MS/s using the "+" and "-" buttons.
The digits can also be entered individually to an accuracy of 0.001 MS/s:
• Press the "←" and "→" buttons simultaneously and then release (starts mode)
• Select the desired digit using the "←" and "→" buttons (selected digit fl ashes)
• Set the digit using the "+" and "-" buttons
• Select and set all of the other digits using the same procedure
• Press the "←" and "→" buttons simultaneously and then release (terminates mode)
4.2 Setting the QAM stages
Twin I
Inp. K10
Outp. S21
6.900 MS/s
Note:
If different QAM stages are possible, it is advantageous to set the lower stage (e.g. 64 or 32 available, select 32).
TP
212.5 MHz
306.00 MHz
64 QAM
TP
212.5 MHz
306.00 MHz
64 QAM
TP
212.5 MHz
306.00 MHz
64 QAM
Twin II
Inp. K56
∗
Outp. S22
6.900 MS/s
Main menu Twin II (switched off)
Select the desired QAM using the "+" and "-" buttons.
QAM stages 16, 32, 64, 128 and 256 are possible.
TP
754.0 MHz
314.00 MHz
64 QAM