Kathrein UFO 356/TP Manual De Instrucciones página 18

The following functions can be selected using the (+) and (-) buttons:
• Set language -
• Version numbers -
• Cable NIT -
The desired function is then activated with the "(sub-menu)" key. The arrow buttons (< >) are used to select parameters in the
sub-menus and values are changed with the (+) and (-) buttons.
► Querying the version number
****
Version numbers
Selection
Main menu
► Settings for generating the cable NIT
**** System
Cable NIT
Selection
Main menu
► "Parameters" sub-menu
NIT: - Insert:
- Generate:
Network: - Name:
- ID:
► Cable NIT settings
A B C D E F G H I J K L M N O P Q R S
T U V W X Y Z 0 1 2 3 4 5 6 7 8 9 _
KATHREIN WERKE KG _
Name sub-menu
The network ID should only be set if the operator applied for and was granted the ID by the ETSI.
The preset value (FF01) is intended for networks without a specifi c network ID.
The network name is set by adding (+) or removing (-) characters at the fl ashing cursor in the third (name) line. The maximum
number of characters is 40. The character to be added is selected in the fi rst two lines by using the (< >) buttons to move
the cursor.
The network ID is selected digit-by-digit using the (< >) buttons and is changed using the (+) or (-) buttons.
Press the (sub-menu) key to exit the sub-menu and save the setting.
German, English, French
Display bootloader version, controller version
On/off, generate, network name, network ID
System ****
with
****
with
Use the "+" and "-" buttons to switch between "on" and "off"
Starts when "+" is pressed
Contains the sub-menu for entering the network name
Contains the sub-menu for entering the network ID
*
Bootloader
Controller
+/-
****
NIT
Network
+/-
Network ID:
Version numbers
V 2.00
V 7.00
Version numbers sub-menu
Cable NIT
on generate
Name
Cable NIT sub-menu
FF01
ID sub-menu
*
****
ID