Kathrein UFO 356/TP Manual De Instrucciones página 19

► Generating the cable NIT, sub-menu
**** Cable NIT
NIT
on
Network
Cable NIT sub-menu
The controller completes the NIT generation process after it is started manually with the (+) button.
The new cable NIT is created and then sent to the channel units with TP (UFO 356/TP).
The procedure can be aborted with the (hash) key.
A progress bar is displayed in the lower display line during the generation process.
The cable NIT that was generated is saved and can now be switched on or off as required.
The following display appears if the process is aborted:
NIT error:
U s e r
Cable NIT sub-menu
The following conditions must be fulfi lled to generate the NIT successfully:
• The system must be fully set up
• All digital channels units must be in operation and registered
The following error messages are possible:
NIT error:
Not all channel
units registered
Cable NIT sub-menu
Pay attention to the following notes when planning a system:
Case 1: Extending an existing UFO
The insert position specifi cation described in the user instructions for UFO 386/TP modules must be complied with for the NIT to
be successfully generated. Any position can then be used for UFO 356/TP.
Case 2: Setting up a new UFO
We recommend only using TP modules in the system (e.g. UFO 356/TP, UFO 390/TP) to ensure that the NIT is generated
successfully.
****
generate
Name ID
a b o r t
compact system
®
® compact system
Cable NIT
being generated
Please wait
....
Cable NIT sub-menu
Switching on the cable NIT:
**** Cable NIT
NIT
Network
Cable NIT sub-menu
NIT error:
Insert position specifi cation
non-compliance
****
on generate
Name
ID