Russell Hobbs 18511-56 Instrucciones página 3

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
diagrams
0 off
1 low
2 high
3 speed control
4 motor unit
Y pulse
5 spindle
6 jug
12 Don't use the appliance for any purpose other than those described in these instructions.
13 Don't operate the appliance if it's damaged or malfunctions.
14 If the cable is damaged, it must be replaced by the manufacturer, its service agent, or
someone similarly qualified, in order to avoid hazard.
R PROCESSING
1 Sit the motor unit on a dry, firm, level surface, near a power socket.
2 Route the cable so it doesn't overhang, and can't be tripped over or caught.
3 Lower the jug on to the motor unit, then turn the jug clockwise, to lock it in place.
4 Remove the lid.
5 Put the ingredients into the jug.
6 Replace the lid.
C SWITCH ON
7 Check that the speed control is set to 0.
8 Put the plug into the power socket.
C SPEED CONTROL
9 Turn the speed control to the speed you want (1 = low, 2 = high).
10 Turn the speed control back to 0 to turn the motor off.
11 Generally, large quantities, thick mixes, and a high ratio of solids to liquids suggest longer
timings and slower speeds.
12 Smaller quantities, thinner mixes, and more liquids than solids suggest shorter timings and
higher speeds.
Y PULSE
13 Turning the speed control anti-clockwise to Y will give you a short burst at high speed. In
this direction, the knob is spring-loaded. When you let go, it'll return to 0.
N USING THE BLENDER
14 Don't run the motor continuously for more than 1½ minutes, it may overheat. After 1½
minutes switch off for at least 2 minutes, to recover.
15 Lower the jug on to the motor unit, then turn the jug clockwise, to lock it in place.
16 Lift the lid off the jug.
17 You'll find it's quite stiff (it has be, to keep the ingredients from escaping when you turn the
motor on).
18 Put the ingredients into the jug.
, Don't fill past the max mark.
19 Put the lid on the jug, and press it down.
20 Align the pips on the sides of the cap with the slots in the hole in the lid, put the cap into the
hole, and turn it about ¼ of a turn clockwise to lock it.
7 handle
8 support
9 blade
10 mixer
11 creamer
12 tab
13 lid
15 pusher
16 disc
household use only
3
17 slicer
18 coarse grater
19 fine grater
20 underside
21 blade unit
22 seal
23 hole
24 pips
25 cap

Publicidad

Tabla de contenido
loading

Tabla de contenido