Package Contents; Description (Fig. A); Electrical Safety - Elu MTS24 Manual De Instrucciones

E N G L I S H

Package contents

The package contains:
1 Toothed chopsaw
1 Cutting blade
1 Allen key
1 Vertical clamp
1 Prism clamp
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and understand
this manual prior to operation.

Description (fig. A)

Your professional Elu toothed chopsaw has been
designed for (angular) cutting of hot and cold rolled
carbon steel, construction steels according to
DIN 1700 (ST33, ST37-2, ST52-3), cast-iron
sewage, water and gas pipes, all types of metal
pipes, angular iron, U-profiles, T-bars, metal bars,
rods, bolts and plastic covered pipes, non-ferrous
metals (i.e. aluminum, brass, copper) and synthetic
materials (i.e. PVC), using the appropriate cutting
blade. This tool is not intended to be used in brick,
tile or ceramic materials. The tool is never to be used
for cutting magnesium workpieces.
1 On/off-switch
2 Control handle
3 Carrying handle
4 Guard
5 Spindle lock
6 Material clamp
7 Fence
8 Mounting holes
9 Cutting table
10 Allen key

Electrical safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your tool is double insulated in
accordance with EN 61029; therefore no
earth wire is required.
en - 4
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
For 115 V units with a power rating exceeding 1500 W,
we recommend to fit a plug to BS4343 standard.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor size
is 1.5 mm 2 . When using a cable reel, always unwind
the cable completely. Also refer to the table below.
.
19