How To Replace The Outer Foil And Inner Blades - Sinbo SS 4033 Manual De Instrucciones

ENGLISH
SINBO SS 4033 SHAVER
INSTRUCTION MANUAL
SIMPLE CHECKING METHOD
You should immediately stop using the shaver if it is malfunctioning. Before sending out
for repairs, you can do a simple checking based on the following checking table:
Type of malfunction
Blunt blade, weak rotation, shorter shelf life
No Indicator light, unable to recharge
Part to examine
Check if there are too much of beard residues accumulated inside the inner blades
Check if the On/Off switch is turned off.
Handing method
Clean regularly by using a clearing brush or spray with blade cleaner
Turn off the On/Off switch and then try to recharge
After you have examined the shaver accordingly and it is still not operating properly,
please contact company for services. DO NOT repair the shaver by yourself.
Special Reminder
Please ensure you have removed the battery from the shaver body and discard it to an
officially assigned location before disposal of the shaver to avoid any unwanted pollution
to the environment. Unlock the back cover of the shaver body to remove the battery.

HOW TO REPLACE THE OUTER FOIL AND INNER BLADES

Please use only genuine outer foils and inner blades that are supplied
by the manufacture.
1. Turn the ON/Off switch off before replacing the outer foil.
2. Detach the outer foil hood. Hold on the foil with fingers at "," point
[indicated as in the diagram] and pull out. Repeat the same on opposite
side to completely release the foil.
3. To insert a new outer foil, slightly bend the foil inward and place
down until it is parallel with (1) (2)
- 5 -