Mitsubishi Electric PAR-U02MEDA Manual De Instrucciones página 12

7 Set the M-NET addresses.
Rotary switches
10's digit
(Above)
1's digit
(Below)
(Ex: Address 108)
Main remote controller
Sub remote controller
Rotary switch setting
01 to 99
00
* The factory setting for the rotary switches is 01.
** M-NET address can be changed with or without the power being applied to the controller.
The screen will jump to the [Start-up] screen.
Group information for indoor units and AHC units will be deleted, but the rest of the information
will be retained.
Important
To set the address, turn the rotary switch
with a precision slotted screwdriver [(-), 2.0
mm (1/16 in) (W)] to a torque of less than
19.6 N to avoid the damage to the rotary
switches.
8 Install the front cover on the top case.
Two mounting tabs are at the top of the front cover.
Hook those two tabs onto the top case, and click the front cover into place. Check that the case is
securely installed and not lifted.
Important
When attaching the front cover to the top
case, push it until it they click into place.
If they are not properly locked into place,
they may fall, causing personal injury,
controller damage, or malfunctions.
Address range
Address that equals the lowest address of the
101 to 150
group plus 100
Address that equals the lowest address of the
151 to 200
group plus 150
101-199 with the 100's digit automatically set to 1
– 11 –
Address setting method
Address
200
Wall
Should not
be lifted