GB
USER MANUAL
A sprayer is a pressure apparatus where there is
always the risk of explosion with a projection of
liquid if the instructions are not followed. If you
have any doubts concerning its use, contact the
manufacturer.
The original manual was written and approved
in French. All other languages are translations
of the original. In the event of a conflict,
imprecisions or discrepancies between the
French and other languages, the French version
shall prevail.
FIELD OF APPLICATION
This apparatus is exclusively designed for the
application of GARDEN PHYTOSANITARY
products, BIOLOGICAL CONTROL products
and for the application of the FORMULAE
presented or proposed by the manufacturer in
the formulae booklet accompanying this product
or on the manufacturer's website. The quantities
of each ingredient in the FORMULAE must be
strictly respected. Comply with the instructions
for use provided by the manufacturer of these
solutions. For any other application, you MUST
consult the manufacturer.
IMPORTANT: This apparatus must not contain
or be used to spray chlorine, solvents or acetone-
based or acid-based products (except vinegar).
Nor should it be used for the application of
bleach, washing products or disinfectants.
Spray compatible with vinegar-based products
authorised for sale on the Swedish market such
as Kraft Attika - List available at www.kemi.se.
INSTRUCTIONS
- Install the two nuts (B) on the piping
- Install the tubing (A) on the dipping tube (K),
then install the pipe (J) on this assembly.
- Install the piping on the reservoir (Fig.9).
- Install the filter (C) on the piping (J)
- Install the piping on the handle (D) (Fig.9).
- Install the clip (G) on the lance tube (L) (Fig.9).
- Install the two nuts on the lance tube. Install
the nozzle on the lance tube and the tube on the
handle (Fig.9).
- Install the connector, which is present
depending on the model, by clipping or screwing
in depending on the model (Fig. 8).
- Install the carrying strap(s), which are present
depending on the model (Fig.10).
- Put the filling filter in place, which is present
depending on the model, when filling the sprayer
(Fig.11).
Seal the filter on the neck by pulling on the
strings. Remove the filter before closing the
sprayer.
- Storing the lance after use (Fig.10)
- Sprayer not compatible with the pressure
regulator manufactured by HOZELOCK-EXEL ref
283983
- Sprayer not compatible with the HOZELOCK
telescopic lance ref 4107
OPERATION
COMMISSIONING / SAFETY RULES
- This apparatus is equipped with a switch that
allows supply to the lance to be stopped as soon
as the switch is no longer being pressed.
- It is equipped with a safety valve calibrated
at the pressure recorded on the valve or on
the reservoir, which limits pressure inside the
reservoir.
- The following are recommended:
- Never remove the valve from the apparatus.
- Do not tamper with the operation of the valve.
- For your own safety, the valve must remain in
perfect working order.
- Before each pressurizing, check that the valve
operates correctly: lift it up manually and then
let go. It should return immediately to its original
position. If this is not the case, do not pressurise
the apparatus.
- Check that the apparatus operates correctly by
checking there are no leaks with several litres of
water in the reservoir.
- The apparatus must not be used or stored at
temperatures under 5°C or over 40°C, neither
during overwintering or during the rest of the
year (Figs. 1 and 2).
- The solution to be sprayed must not exceed
25°C (Fig. 3).
- Only use in calm weather (no wind).
- Do not use explosive, acidic, and/or corrosive
products in the sprayer (Figs. 4 and 5).
- Do not spray in the direction of flames or other
heat sources.
- Wear protective clothing, protective gloves,
protective goggles and a protective mask (Fig. 6).
- Do not smoke, eat or drink during use.
- Do not spray in the direction of other people or
pets.
- Keep other people and pets at a reasonable
distance from the apparatus when spraying (Fig. 7).
- Help protect the environment, only spray
surfaces to be treated.
- Never remove a part of the sprayer without
having previously released the pressure.
- This apparatus must not be used by individuals
suffering from fatigue or illness, or by any person
under the influence of alcohol, drugs or other
medication.
FILLING
- Follow the manufacturer's instructions for the
treatment agents (dosage, application method,
rinsing).
6