Replacement Accessories - DeWalt DCM5713 Traducido De Las Instrucciones Originales

página de 157

/ 157
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

WARNING:

personal injury, turn tool off and disconnect battery

pack before making any adjustments or removing/

installing attachments or accessories. An accidental

start-up can cause injury.

Proper Hand Position (Fig. A, E)

WARNING:

personal injury, ALWAYS use proper hand position

as shown.

WARNING:

personal injury, ALWAYS hold securely in anticipation of a

sudden reaction.

Proper hand position requires one hand on the handle

the other hand on the auxiliary handle

Switching On (Fig. A)

To turn the appliance on, push the lock off tab

squeeze the lock-off lever

, and then squeeze the variable

speed trigger

To turn the appliance off, release the variable speed trigger, the

lock-off lever, and tab.

Speed Control Switch (Fig. A)

This Grass Trimmer gives you the choice to operate at a

more efficient speed to extend the runtime for larger jobs, or

accelerate the trimmer speed for high-performance cutting.

To extend runtime, push the speed control switch

toward the auxiliary handle

is best for larger projects that require more time to complete.

To accelerate the trimmer, pull the speed control switch back

toward the battery housing

is best to cut through heavier growth and for applications that

need higher RPM.

nOTE: When in "HI" mode, runtime will be decreased as

compared to when trimmer is in "LO" mode.

Trimming (Fig. A, E, F)

With the trimmer on, angle it and swing side to side as shown

in Figure E.

Maintain a minimum distance of 610 mm between the guard

and your feet as shown in Figure F.

WARNING:

parallel with the ground (tilted no more than 30 degrees).

This trimmer is not an edger. DO NOT TILT the trimmer so

that the string is spinning near a right angle to the ground.

Flying debris can cause serious injury.

Bump Feed Trimmer Line Feed

Your trimmer uses 2.032 mm diameter nylon line. Cutting line

will wear faster and require more feeding if the cutting is done

To reduce the risk of serious

, with

forward,

forward

into the "LO" position. This mode

into the "HI" position. This mode

Keep the rotating string roughly

along sidewalks or other abrasive surfaces or heavier weeds are

being cut.

As you use the trimmer, the string will get shorter due to wear.

Gently bump the trimmer on the ground while running at

normal speed and the line will feed.

nOTE: Extending nylon line beyond the 330 mm swath will

negatively affect performance, runtime, and the life of the

trimmer due to potential of damaging motor. Doing so may

void the warranty.

Helpful Cutting Tips

•

Use the tip of the string to do the cutting; do not force string

head into uncut grass.

•

Wire and picket fences cause extra string wear, even

breakage. Stone and brick walls, curbs, and wood may wear

string rapidly.

•

Do not allow spool cap to drag on ground or other surfaces.

•

In long growth, cut from the top down and do not exceed

304.8 mm high.

•

Keep trimmer tilted toward the area being cut; this is the

best cutting area.

•

The trimmer cuts when passing the unit from the left to

right. This will avoid throwing debris at the operator.

•

Avoid trees and shrubs. Tree bark, wood moldings, siding, and

fence posts can easily be damaged by the string.