Care And Maintenance - EHEIM skim350 Manual Del Usuario

Do not clean the unit – or parts of it – in the dish-
water. Not dishwater resistant!
Do not dispose of this product as normal house-
hold waste. Take it to your local refuse collection
side.
The product is qualified in
accordance with the respec-
tive national regulations and guidelines and meets
EC standards.
Definition
a b
Float
d
tridge Pump cover with power regulator
f
tion units
B Installation and operation
Press the 3 suction units
the pump cover
power cord into the cable guide
surface skimmer to the inside wall of the aquarium below
the water level. The float
3 cm from the float chamber.
TIP: Place the micro surface skimmer so that the float pro-
trudes as far as possible from the float chamber (max.
3 cm), with the aquarium filled to the maximum. Thus,
sinking of water level through evaporation can be opti-
mally compensated.
TIP: To prevent the introduction of air bubbles, the power
d
regulator
initial installation or use of a new filter cartridge. s the
water becomes dirtier, the power regulator can then be gra-
dually increased to maximum level.
Following installation, put the micro surface skimmer into
operation by plugging in the power cord.
C

Care and maintenance

Pull out the power cord. Remove the float. Tilt the float
chamber upwards by applying gentle pressure
Float chamber with cable clip
Pump wheel
d
with a rotating movement. Insert the
should be set at a minimum level during the
g
Motorbody.
e
into the lateral openings of
b
and secure the micro
a
may not protrude more than
c
Filter car-
e
3 x suc-
A
and re-