Elnur Gabarron CCB-2000 Manual De Instrucciones página 10

3.3. Set the day / time
Click the ON/OFF button to switch on the device. The display will show 00:00 and display
- WEEK. Click the "Set" button on the remote control and it will flash
or "-" to set the correct day (Mo= Monday...Su= Sunday, etc.).
- TIME. Click the "Set" button again until it reaches the time. The hours will flash on the display.
Click "+" or "-" to set the correct time.
- MINUTES. Click the "Set" button again. The minutes will flash on the display. Click "+" or "-" to
set the correct minutes.
Finally, click the "Set" button and the day and time values will be set in the device.
3.4. General operating modes.
In the general operating modes, the device will operate in the relevant mode (cold air, heating mode),
regardless of the room temperature.
3.4.1. Cold air mode. Switch on the heater by clicking the ON/OFF button on the remote control. The
unit will start to operate in cold air mode. The room temperature will be shown and the RT (Real
Temperature) icon will appear on the display.
3.4.2. Heating Mode. Power 1 (1000W). Click the "Mode" button again on the control. The first
power level connects and blows hot air from the device. The
3.4.3. Heating Mode. Power 2 (2000W). Click the "Mode" button of control again. The second
power level connects. The
If you click the "Mode" button again, the unit will return to cold air mode.
Note. For manual operation, in case you do not have a remote control, you should click the start button
found next to the switch, at the rear of the device. The heater will connect in heating mode and at power
level 2. The symbol will light up.
Main Switch
Start Button
symbol lights up on the display.
symbol lights up on the display.
9
(Monday).
. Click the buttons "+"