Installation Instructions; Installing Your Gas Cooktop; Step 1. Unpack The Cooktop; Step 2. Installing The Cooktop - Samsung NA24T4230FS Manual De Instalación

Gas cooktops
• All gas models are equipped with a power cord with an equipment-grounding
conductor and a grounding plug.
• A 120-Volt, 60-Hz, AC, approved electrical service with 15-amp circuit breaker or
time-delay fuse is required for all U.S. and Canadian models.
Grounding
• All cooktops must be grounded for personal safety.
• The plug must be firmly plugged into a three-prong outlet that is properly
installed and grounded in accordance with all local codes and ordinances. In
the event of a malfunction or breakdown, grounding will decrease the risk of
electrical shock by providing a path for the electric current.
• Do not use a damaged power plug or loose wall outlet.
• Do not use an extension cord or adapter with this appliance
• Do not, under any circumstances, cut, modify, remove, or otherwise defeat the
grounding (third) prong from the power cord. If the plug and the outlet do not
match or you have any doubt, have a qualified electrician install the proper
outlet. The customer should have the wall receptacle and circuit checked by a
qualified electrician to make sure the receptacle is properly grounded.
• NEVER connect ground wire to plastic plumbing lines, gas lines, or water pipes.
CAUTION
Failure to follow these instructions can result in death, fire, or electrical shock.
Additional installation requirements for mobile homes
The installation of appliances designed for mobile home installation must conform
with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part
3280 (formerly the Federal Standard for Mobile Home Construction and Safety,
Title 24, HUD, Part 280) or, when such standard is not applicable, the Standard
for Manufactured Home Installations, latest edition (Manufactured Home Sites,
Communities and Set-Ups), ANSI A225.1, latest edition, or with local codes. In
Canada, mobile home installation must be in accordance with the current CAN/CSA
Z240/MH Mobile Home Installation Code.
14 English

Installation instructions

Installing your gas cooktop

IMPORTANT:
Please read the following instructions, as well as the Important Safety Instructions
section at the front of this manual, completely and carefully BEFORE installing
and/or operating the gas cooktop. Improper installation, adjustment, service, or
maintenance can cause personal injury or property damage.
NOTE
To ensure proper installation, we strongly recommend that you hire a professional
installer.

Step 1. Unpack the cooktop

Remove all packaging materials. Failure to remove packaging materials could
result in damage to the appliance.
Inventory all loose parts against the Parts supplied components listed on page 8.
Check for shipping damage and/or missing parts. Any damage and/or missing
parts should be reported to your local retailer.
Step 2-2. Installing the cooktop
1.
(A)
(B) (B)
2.
(A)
foam tape
3.
Bottom view
The thickness of the foam tape is 1.5mm
(A)The width of the foam tape is 10mm
(B)The width of the foam tape is 20mm
Remove the pan supports, the burner lid
and flame spreader and carefully turn the
appliance upside down and place it on a
cushioned mat.
Take care that the ignition devices and
flame supervision devices are not
damaged in this operation.
Apply the foam tape provided around
the edge of the appliance.
Do not leave a gap in the sealing agent or
overlap the thickness.