Important Safety Instructions For Battery Chargers - DeWalt DW0242 Manual Del Usuario

battery to an authorized D WALT service center or to your local retail-
E
er for recycling. You may also contact your local recycling center for
information on where to drop off the spent battery.
Important Safety Instructions for
Battery Chargers
SAVE THESE INSTRUCTIONS: This manual contains important
safety instructions for battery chargers.
• Before using charger, read all instructions and cautionary markings
on charger, battery pack, and product using battery pack.
CAUTION: To reduce the risk of injury, charge only D
cadmium rechargeable batteries. Other types of batteries may burst
causing personal injury and damage.
CAUTION: Under certain conditions, with the charger plugged in to
the power supply, the exposed charging contacts inside the charger
can be shorted by foreign material. Foreign materials of a conductive
nature such as, but not limited to, steel wool, aluminum foil, or any
buildup of metallic particles should be kept away from charger cavi-
ties. Always unplug the charger from the power supply when there is
no battery pack in the cavity. Unplug charger before attempting to
clean.
DANGER: 120 volts are present at charging terminals. Do not
probe with conductive objects. Electric shock or electrocution may
result.
WARNING: Do not allow any liquid to get inside charger. Electric
shock may result.
• DO NOT attempt to charge the battery pack with any chargers
other than the ones in this manual. The charger and battery
pack are specifically designed to work together.
• These chargers are not intended for any uses other than
charging D WALT rechargeable batteries. Any other uses may
E
result in risk of fire, electric shock or electrocution.
• Do not expose charger to rain or snow.
All manuals and user guides at all-guides.com
• Pull by plug rather than cord when disconnecting charger.
• Make sure that cord is located so that it will not be stepped on,
• Do not use an extension cord unless it is absolutely neces-
• An extension cord must have adequate wire size (AWG or
WALT nickel
E
• Do not place any object on top of charger or place the charg-
• Do not operate charger with damaged cord or plug — have
• Do not operate charger if it has received a sharp blow, been
• Do not disassemble charger; take it to an authorized service
4
This will reduce risk of damage to electric plug and cord.
tripped over, or otherwise subjected to damage or stress.
sary. Use of improper extension cord could result in risk of fire,
electric shock, or electrocution.
American Wire Gauge) for safety. The smaller the gauge number
of the wire, the greater the capacity of the cable, that is 16 gauge
has more capacity than 18 gauge. When using more than one
extension to make up the total length, be sure each individual
extension contains at least the minimum wire size.
Recommended Minimum Wire Size for Extension Cords
Total Length of Cord
25 ft. 50 ft. 75 ft. 100 ft. 125 ft.
7.6 m 15.2 m 22.9 m 30.5 m 38.1 m 45.7 m
Wire Size AWG
18 18 16 16
er on a soft surface that might block the ventilation slots and
result in excessive internal heat. Place the charger in a position
away from any heat source. The charger is ventilated through slots
in the top and the bottom of the housing.
them replaced immediately.
dropped, or otherwise damaged in any way. Take it to an autho-
rized service center.
center when service or repair is required. Incorrect reassembly
may result in a risk of electric shock, electrocution or fire.
150 ft. 175 ft.
53.3 m
14 14 12