Publicidad
Idiomas disponibles
Idiomas disponibles
Notice recepteur 2000W 1840041
Use this radio unit to remotely control maximum 2000 watt lighting. The remote control unit can:
• Switch the lighting ON
• Program lighting switch OFF and connection to an external control.
• Memorize 12 channels of a SOMFY RTS remote control unit.
1 C
haracteristics and description
• Input/Output power supply:
• Receiver and frequency type:
• Dimension (mm):
• Maximum power:
• Operating temperature:
• Protection index:
2
1
1) Housing with receiver and plexiglas cover.
3) Screw and wall attachment plug.
A) Transformer.
B) Power fuse F1 (10A) for 2000W. Adjust for the power rating of the secondary appliance.
C) Terminals.
2 I
nstallation
Layout and attachment
The receiver must be located away from sources of interference (alarm systems, radio trans-
missions, headsets, etc...) witch could affect receiver correct operation.
5
Connection
When working on the receiver, turn OFF the power supply before removing the Plexiglas cover.
Respect electrical installation standards in force in the country of use.
The normally open push button switch between terminals 7 and 8 performs the same func-
tions as the remote control unit.
3 P
rogramming
7
Dip switch positions determine operating modes.
Switch 8: selection of timing units: seconds and minutes or minutes and hours.
ON/OFF operation: switches from 1 to 8 are all set to OFF.
"Timer" operation: switches from 1 to 8 determine the time lighting stays ON (switch times are
additive).
Example: 8 to OFF: 3 to ON + 1 to ON = 50 s. 8 to ON : 3 to ON + 1 to ON = 50 min (see table).
• Remote unit programming: (range approximately 70m in line of sight)
Press PR on the receiver until the LED comes ON. Release PR and press the unit key that
you want to memorize. The led flashes and then goes OFF. The remote unit key is stored in
memory. Repeat the operation for all the remote control keys:
• Cancellation of all memorized remote control keys : press PR for 7s until LR flashes.
Release PR.
• Cancellation of one remote control key: reprogram the key in question as shown in
"remote control key memorization" above.
13/05/04
Installation instructions
230V/50Hz
Super heterodyne, 433.42 MHz
140 x 115 x 52
2000 W at 230 Vac
-20°C to + 60°C
IP44
D) Dip switches.
E) PR programming key and LR led.
3
4
6
We,SOMFY, declare that this product complies with essential requirements and other relevant stipulations in EC
directive 1999/5. A certificate of compliance is available on our web site: www.somfy.com/ce
14:57
Page 4
2) Cover and screw.
4) Aerial.
Publicidad
